​

The Radio Log is a module, which can be called by pressing F8 anywhere in L.A.S.S.I.E.. It will be available if L.A.S.S.I.E. is connected to a Pi-Star with pistarlog2ws installed (green antenna symbol) and subsequently show the DMR radio traffic.

Pi-Star

Installation

Pi-Star has to be installed on a Raspberry Pi (Zero) with a MMDVM HAT. A non-duplex MMDVM HAT is fully sufficient since Pi-Star only can monitor one single frequency and sending is not something this setup is expected to do. See https://www.pistar.uk/downloads/ for download and installation instructions.

The SD card for the Raspberry Pi will be flashed using Raspberry Pi Imager. During the process, you will be asked if you like to apply OS customization settings. You can change the hostname, wireless LAN and locale settings here. Do not set username and password, or anything in the Services or Options tab!

After flashing and booting the Raspberry from the SD card, you should be able to access the Pi-Star Webinterface via browser at e.g. http://radiolog.local/admin/

Configuration

After installing Pi-Star, the following configuration should be used for the Radio Log. First, in the MMDVMHost Configuration section the DMR Mode should be enabled. Please remember to press “Apply Changes” afer every section