Wiki source code of Radio Log
Version 10.5 by Treyfane Dingo on 2025/04/07 20:47
Show last authors
| author | version | line-number | content |
|---|---|---|---|
| 1 | [[image:radiolog1.png]] | ||
| 2 | |||
| 3 | |||
| 4 | The Radio Log is a module, which can be called by pressing F8 anywhere in L.A.S.S.I.E.. It will be available if L.A.S.S.I.E. is connected to a [[Pi-Star>>https://www.pistar.uk/]] with [[pistarlog2ws>>https://git.furcom.org/Dingo/pistarlog2ws]] installed (green antenna symbol) and subsequently show the DMR radio traffic. | ||
| 5 | |||
| 6 | = Pi-Star Installation = | ||
| 7 | |||
| 8 | Pi-Star has to be installed on a Raspberry Pi (Zero) with a MMDVM HAT. A non-duplex MMDVM HAT is fully sufficient since Pi-Star only can monitor one single frequency and sending is not something this setup is expected to do. See [[https:~~/~~/www.pistar.uk/downloads/>>https://www.pistar.uk/downloads/]] for download and instructions. The image will be flashed to a SD C | ||
| 9 | |||
| 10 | After Pi-Star is installed , the following configuration should be done. To configure the freshly installed Pi-Star, connect to the web interface using your hostname, e.g. [[http:~~/~~/radiolog.local/admin/>>http://radiolog.local/admin/]] | ||
| 11 | |||
| 12 | Pi-Star Configuration | ||
| 13 | |||
| 14 | |||
| 15 | [[image:radiolog_cfg1.png]][[image:radiolog_cfg2.png]][[image:radiolog_cfg3.png]][[image:radiolog_cfg4.png]][[image:radiolog_cfg5.png]] |