Wiki source code of Radio Log
Version 10.12 by Treyfane Dingo on 2025/04/07 20:52
Hide last authors
| author | version | line-number | content |
|---|---|---|---|
 |
2.2 | 1 | [[image:radiolog1.png]] |
| 2 | |||
| |
2.3 | 3 | |
| |
5.3 | 4 | The Radio Log is a module, which can be called by pressing F8 anywhere in L.A.S.S.I.E.. It will be available if L.A.S.S.I.E. is connected to a [[Pi-Star>>https://www.pistar.uk/]] with [[pistarlog2ws>>https://git.furcom.org/Dingo/pistarlog2ws]] installed (green antenna symbol) and subsequently show the DMR radio traffic. |
| 5 | |||
| |
10.7 | 6 | = Pi-Star = |
| |
5.3 | 7 | |
| |
10.8 | 8 | == Installation == |
| 9 | |||
| |
10.10 | 10 | Pi-Star has to be installed on a Raspberry Pi (Zero) with a MMDVM HAT. A non-duplex MMDVM HAT is fully sufficient since Pi-Star only can monitor one single frequency and sending is not something this setup is expected to do. See [[https:~~/~~/www.pistar.uk/downloads/>>https://www.pistar.uk/downloads/]] for download and installation instructions. |
| |
5.5 | 11 | |
| |
10.12 | 12 | The image will be flashed to a SD card using the [[Raspberry Pi Imager>>https://www.raspberrypi.com/documentation/computers/getting-started.html#raspberry-pi-imager]]. During the installation, when prompted if you like to apply OS customization settings |
| |
10.10 | 13 | |
| |
10.8 | 14 | == Configuration == |
| |
10.7 | 15 | |
| |
10.8 | 16 | After Pi-Star is installed , the following configuration should be done. To configure the freshly installed Pi-Star, connect to the web interface using your hostname, e.g. [[http:~~/~~/radiolog.local/admin/>>http://radiolog.local/admin/]]. |
| |
5.6 | 17 | |
| |
10.9 | 18 | Default Username: pi-star |
| 19 | Default Password: raspberry | ||
| |
10.3 | 20 | |
| 21 | |||
| |
10.8 | 22 | |
| |
10.2 | 23 | [[image:radiolog_cfg1.png]][[image:radiolog_cfg2.png]][[image:radiolog_cfg3.png]][[image:radiolog_cfg4.png]][[image:radiolog_cfg5.png]] |