Skip to Content

Changes for page Radio Log

Last modified by Treyfane Dingo on 2025/04/27 13:33
From version 21.2
edited by Treyfane Dingo
on 2025/04/07 21:40
Change comment: There is no comment for this version
To version 19.2
edited by Treyfane Dingo
on 2025/04/07 21:28
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -5,7 +5,7 @@
5 5  
6 6  = Pi-Star =
7 7  
8 -== OS Installation ==
8 +== Installation ==
9 9  
10 10  Pi-Star has to be installed on a Raspberry Pi (Zero) with a MMDVM HAT. A non-duplex MMDVM HAT is fully sufficient since Pi-Star only can monitor one single frequency and sending is not something this setup is expected to do. See [[https:~~/~~/www.pistar.uk/downloads/>>https://www.pistar.uk/downloads/]] for download and installation instructions.
11 11  
... ... @@ -20,7 +20,7 @@
20 20  
21 21  == Configuration ==
22 22  
23 -After installing Pi-Star, the following configuration should be used for the Radio Log. First, in the “General Configuration” section the Radio Frequency has to be set to the **output** frequency of your DMR repeater. Also the correct Radio/Modem Type has to be selected, depending on the MMDVM HAT used, and the Node Type has to be set to “Public”. **Please remember to press “Apply Changes” after changing every section.** Depending on the changes some options may only show after pressing “Apply Changes”.
23 +After installing Pi-Star, the following configuration should be used for the Radio Log. First, in the “General Configuration” section the Radio Frequency has to be set to the **output** frequency of your DMR repeater. Also the correct Radio/Modem Type has to be selected, depending on the MMDVM HAT used, and the Node Type has to be set to “Public”. **Please remember to press “Apply Changes” after changing every section.** Depending on the changes otheoptions may only show after pressing “Apply Changes”.
24 24  
25 25  [[image:radiolog_cfg2.png]]
26 26  
... ... @@ -28,10 +28,6 @@
28 28  
29 29  [[image:radiolog_cfg1.png]]
30 30  
31 -After enabling the DMR Mode in the “MMDVMHost Configuration” section, you should head over to “Expert” → “MMDVMHost” in the top menu. Here it is imperative to set Enable = 0 in
32 -
33 -[[image:radiolog_cfg2b.png]]
34 -
35 35  In the “DMR Configuration” section it is imperative to disable all three Networks. We don't want to have the Radio Log Pi-Star send out our private DMR communication to the world after all.
36 36  
37 37  [[image:radiolog_cfg3.png]]
radiolog_cfg2a.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.dingo
Size
... ... @@ -1,1 +1,0 @@
1 -23.1 KB
Content
radiolog_cfg2b.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.dingo
Size
... ... @@ -1,1 +1,0 @@
1 -26.9 KB
Content