Skip to Content

Changes for page Radio Log

Last modified by Treyfane Dingo on 2025/04/27 13:33
From version 19.8
edited by Treyfane Dingo
on 2025/04/07 21:38
Change comment: There is no comment for this version
To version 13.3
edited by Treyfane Dingo
on 2025/04/07 21:09
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -5,7 +5,7 @@
5 5  
6 6  = Pi-Star =
7 7  
8 -== OS Installation ==
8 +== Installation ==
9 9  
10 10  Pi-Star has to be installed on a Raspberry Pi (Zero) with a MMDVM HAT. A non-duplex MMDVM HAT is fully sufficient since Pi-Star only can monitor one single frequency and sending is not something this setup is expected to do. See [[https:~~/~~/www.pistar.uk/downloads/>>https://www.pistar.uk/downloads/]] for download and installation instructions.
11 11  
... ... @@ -13,34 +13,8 @@
13 13  
14 14  **~ **[[image:radiolog_set3.png]]
15 15  
16 -After flashing and booting the Raspberry from the SD card, you should be able to access the Pi-Star webinterface via browser at e.g. [[http:~~/~~/radiolog.local/admin/>>http://radiolog.local/admin/]]
16 +After flashing and booting the Raspberry from the SD card, you should be able to access the Pi-Star Webinterface via browser at e.g. [[http:~~/~~/radiolog.local/admin/>>http://radiolog.local/admin/]]
17 17  
18 -Default Username: pi-star
19 -Default Password: raspberry
20 -
21 21  == Configuration ==
22 22  
23 -After installing Pi-Star, the following configuration should be used for the Radio Log. First, in the “General Configuration” section the Radio Frequency has to be set to the **output** frequency of your DMR repeater. Also the correct Radio/Modem Type has to be selected, depending on the MMDVM HAT used, and the Node Type has to be set to “Public”. **Please remember to press “Apply Changes” after changing every section.** Depending on the changes some options may only show after pressing “Apply Changes”.
24 -
25 -[[image:radiolog_cfg2.png]]
26 -
27 -(% id="cke_bm_335101S" style="display:none" %) (%%)In the “MMDVMHost Configuration” section the DMR Mode should be enabled.
28 -
29 -[[image:radiolog_cfg1.png]]
30 -
31 -After enabling the DMR Mode in the “MMDVMHost Configuration” section, you should head over to “Expert” → “MMDVM
32 -
33 -In the “DMR Configuration” section it is imperative to disable all three Networks. We don't want to have the Radio Log Pi-Star send out our private DMR communication to the world after all.
34 -
35 -[[image:radiolog_cfg3.png]]
36 -
37 -In the “Wireless Configuration”, the IP address of the Pi-Star acquired by DHCP is shown. This IP address has to be configured as “IP for a FurCom Services Radio Log system” in L.A.S.S.I.E. (System Settings → General Settings).
38 -
39 -[[image:radiolog_cfg4.png]]
40 -
41 -For the configuration to be completed and usable, you should change the default password to something more secure. Please remember the password!
42 -
43 -[[image:radiolog_cfg5.png]]
44 -
45 -
46 -
20 +After installing Pi-Star, the following configuration should be used for the Radio Log.