Skip to Content

Changes for page Radio Log

Last modified by Treyfane Dingo on 2025/04/27 13:33
From version 19.2
edited by Treyfane Dingo
on 2025/04/07 21:28
Change comment: There is no comment for this version
To version 19.5
edited by Treyfane Dingo
on 2025/04/07 21:28
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -5,7 +5,7 @@
5 5  
6 6  = Pi-Star =
7 7  
8 -== Installation ==
8 +== OS Installation ==
9 9  
10 10  Pi-Star has to be installed on a Raspberry Pi (Zero) with a MMDVM HAT. A non-duplex MMDVM HAT is fully sufficient since Pi-Star only can monitor one single frequency and sending is not something this setup is expected to do. See [[https:~~/~~/www.pistar.uk/downloads/>>https://www.pistar.uk/downloads/]] for download and installation instructions.
11 11  
... ... @@ -20,7 +20,7 @@
20 20  
21 21  == Configuration ==
22 22  
23 -After installing Pi-Star, the following configuration should be used for the Radio Log. First, in the “General Configuration” section the Radio Frequency has to be set to the **output** frequency of your DMR repeater. Also the correct Radio/Modem Type has to be selected, depending on the MMDVM HAT used, and the Node Type has to be set to “Public”. **Please remember to press “Apply Changes” after changing every section.** Depending on the changes otheoptions may only show after pressing “Apply Changes”.
23 +After installing Pi-Star, the following configuration should be used for the Radio Log. First, in the “General Configuration” section the Radio Frequency has to be set to the **output** frequency of your DMR repeater. Also the correct Radio/Modem Type has to be selected, depending on the MMDVM HAT used, and the Node Type has to be set to “Public”. **Please remember to press “Apply Changes” after changing every section.** Depending on the changes some options may only show after pressing “Apply Changes”.
24 24  
25 25  [[image:radiolog_cfg2.png]]
26 26