Skip to Content

Changes for page Radio Log

Last modified by Treyfane Dingo on 2025/04/27 13:33
From version 16.3
edited by Treyfane Dingo
on 2025/04/07 21:13
Change comment: There is no comment for this version
To version 13.1
edited by Treyfane Dingo
on 2025/04/07 21:07
Change comment: Uploaded new attachment "radiolog_set3.png", version {1}

Summary

Details

Page properties
Content
... ... @@ -9,24 +9,10 @@
9 9  
10 10  Pi-Star has to be installed on a Raspberry Pi (Zero) with a MMDVM HAT. A non-duplex MMDVM HAT is fully sufficient since Pi-Star only can monitor one single frequency and sending is not something this setup is expected to do. See [[https:~~/~~/www.pistar.uk/downloads/>>https://www.pistar.uk/downloads/]] for download and installation instructions.
11 11  
12 -The SD card for the Raspberry Pi will be flashed using [[Raspberry Pi Imager>>https://www.raspberrypi.com/software/]]. During the process, you will be asked if you like to apply OS customization settings. You can change the //hostname//, //wireless LAN// and //locale settings// here. **Do not set username and password, or anything in the Services or Options tab!**
12 +The SD card for the Raspberry Pi will be flashed using [[Raspberry Pi Imager>>https://www.raspberrypi.com/software/]]. When using the Imager, you will be asked if you like to apply OS customization settings. You can change the hostname, wireless LAN and locale settings here. **Do not set an username or password, or anything in Services or Options tab!**
13 13  
14 -**~ **[[image:radiolog_set3.png]]
15 -
16 16  After flashing and booting the Raspberry from the SD card, you should be able to access the Pi-Star Webinterface via browser at e.g. [[http:~~/~~/radiolog.local/admin/>>http://radiolog.local/admin/]]
17 17  
18 18  == Configuration ==
19 19  
20 -After installing Pi-Star, the following configuration should be used for the Radio Log. First, in the “MMDVMHost Configuration” section the DMR Mode should be enabled. Please remember to press “Apply Changes” after changing every section.
21 -
22 -[[image:radiolog_cfg1.png]]
23 -
24 -In the “General Configuration” section the Radio Frequency has to be set to the **output** frequency of your DMR repeater. Also the correct Radio/Modem Type has to be selected, depending on the MMDVM HAT used, and the Node Type has to be set to “Public”.
25 -
26 -[[image:radiolog_cfg2.png]]
27 -
28 -In the “DMR Configuration” section it is imperative to disa
29 -
30 -[[image:radiolog_cfg3.png]]
31 -
32 -
18 +After installing Pi-Star, the following configuration should be used for the Radio Log.