Skip to Content

Changes for page Radio Log

Last modified by Treyfane Dingo on 2025/04/27 13:33
From version 13.2
edited by Treyfane Dingo
on 2025/04/07 21:07
Change comment: There is no comment for this version
To version 15.1
edited by Treyfane Dingo
on 2025/04/07 21:10
Change comment: Uploaded new attachment "radiolog_cfg2.png", version {1}

Summary

Details

Page properties
Content
... ... @@ -9,7 +9,7 @@
9 9  
10 10  Pi-Star has to be installed on a Raspberry Pi (Zero) with a MMDVM HAT. A non-duplex MMDVM HAT is fully sufficient since Pi-Star only can monitor one single frequency and sending is not something this setup is expected to do. See [[https:~~/~~/www.pistar.uk/downloads/>>https://www.pistar.uk/downloads/]] for download and installation instructions.
11 11  
12 -The SD card for the Raspberry Pi will be flashed using [[Raspberry Pi Imager>>https://www.raspberrypi.com/software/]]. When using the Imager, you will be asked if you like to apply OS customization settings. You can change the hostname, wireless LAN and locale settings here. **Do not set an username or password, or anything in Services or Options tab!**
12 +The SD card for the Raspberry Pi will be flashed using [[Raspberry Pi Imager>>https://www.raspberrypi.com/software/]]. During the process, you will be asked if you like to apply OS customization settings. You can change the //hostname//, //wireless LAN// and //locale settings// here. **Do not set username and password, or anything in the Services or Options tab!**
13 13  
14 14  **~ **[[image:radiolog_set3.png]]
15 15  
... ... @@ -17,4 +17,7 @@
17 17  
18 18  == Configuration ==
19 19  
20 -After installing Pi-Star, the following configuration should be used for the Radio Log.
20 +After installing Pi-Star, the following configuration should be used for the Radio Log. First, in the MMDVMHost Configuration section the DMR Mode should be enabled. Please remember to press “Apply Changes” afer every section
21 +
22 +
23 +