Skip to Content

Changes for page Radio Log

Last modified by Treyfane Dingo on 2025/04/27 13:33
From version 11.1
edited by Treyfane Dingo
on 2025/04/07 20:59
Change comment: Uploaded new attachment "radiolog_set3.png", version {1}
To version 11.2
edited by Treyfane Dingo
on 2025/04/07 21:00
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -9,10 +9,12 @@
9 9  
10 10  Pi-Star has to be installed on a Raspberry Pi (Zero) with a MMDVM HAT. A non-duplex MMDVM HAT is fully sufficient since Pi-Star only can monitor one single frequency and sending is not something this setup is expected to do. See [[https:~~/~~/www.pistar.uk/downloads/>>https://www.pistar.uk/downloads/]] for download and installation instructions.
11 11  
12 -The image downloaded will be flashed to a SD card using the [[Raspberry Pi Imager>>https://www.raspberrypi.com/software/]]. While flashing, when asked if you like to apply OS customization settings, you can set the hostname, the wireless LAN and locale settings. **Do not set / change any settings in Services or Options!**
12 +The image downloaded will be flashed to a SD card using the [[Raspberry Pi Imager>>https://www.raspberrypi.com/software/]]. While flashing, when asked if you like to apply OS customization settings, you can set the hostname, the wireless LAN and locale settings. **Do not set / change Usernany settings in Services or Options!**
13 13  
14 -After flashing the Sinstallation, your Pi-Star can be accessed via webinterface
14 +[[image:radiolog_set3.png]]
15 15  
16 +After flashing the SD card and booting the Raspberry with it, your Pi-Star should be accessible via webinterface, e.g. [[https:~~/~~/radiolog.local/admin/>>https://radiolog.local/admin/]]
17 +
16 16  == Configuration ==
17 17  
18 18  After Pi-Star is installed, the following configuration should be done.