Skip to Content

Changes for page Radio Log

Last modified by Treyfane Dingo on 2025/04/27 13:33
From version 10.9
edited by Treyfane Dingo
on 2025/04/07 20:51
Change comment: There is no comment for this version
To version 10.10
edited by Treyfane Dingo
on 2025/04/07 20:52
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -7,8 +7,10 @@
7 7  
8 8  == Installation ==
9 9  
10 -Pi-Star has to be installed on a Raspberry Pi (Zero) with a MMDVM HAT. A non-duplex MMDVM HAT is fully sufficient since Pi-Star only can monitor one single frequency and sending is not something this setup is expected to do. See [[https:~~/~~/www.pistar.uk/downloads/>>https://www.pistar.uk/downloads/]] for download and instructions. The image will be flashed to a SD card using the [[Raspberry Pi Imager>>https://www.raspberrypi.com/documentation/computers/getting-started.html#raspberry-pi-imager]].
10 +Pi-Star has to be installed on a Raspberry Pi (Zero) with a MMDVM HAT. A non-duplex MMDVM HAT is fully sufficient since Pi-Star only can monitor one single frequency and sending is not something this setup is expected to do. See [[https:~~/~~/www.pistar.uk/downloads/>>https://www.pistar.uk/downloads/]] for download and installation instructions.
11 11  
12 +The image will be flashed to a SD card using the [[Raspberry Pi Imager>>https://www.raspberrypi.com/documentation/computers/getting-started.html#raspberry-pi-imager]]. During the installation, when prompted if you like to apply OS customization se
13 +
12 12  == Configuration ==
13 13  
14 14  After Pi-Star is installed , the following configuration should be done. To configure the freshly installed Pi-Star, connect to the web interface using your hostname, e.g. [[http:~~/~~/radiolog.local/admin/>>http://radiolog.local/admin/]].