Skip to Content

Changes for page Radio Log

Last modified by Treyfane Dingo on 2025/04/27 13:33
From version 10.2
edited by Treyfane Dingo
on 2025/04/07 20:35
Change comment: There is no comment for this version
To version 5.3
edited by Treyfane Dingo
on 2025/04/07 20:27
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -3,10 +3,6 @@
3 3  
4 4  The Radio Log is a module, which can be called by pressing F8 anywhere in L.A.S.S.I.E.. It will be available if L.A.S.S.I.E. is connected to a [[Pi-Star>>https://www.pistar.uk/]] with [[pistarlog2ws>>https://git.furcom.org/Dingo/pistarlog2ws]] installed (green antenna symbol) and subsequently show the DMR radio traffic.
5 5  
6 -= Pi-Star Configuration =
6 +Pi-Star Configuration
7 7  
8 -Pi-Star has to be installed on a Raspberry Pi (Zero) with a MMDVM HAT. A non-duplex MMDVM HAT is fully sufficient since Pi-Star only can monitor one single frequency and sending is not something this setup is expected to do.
9 -
10 -After Pi-Star is installed (see [[https:~~/~~/www.pistar.uk/downloads/>>https://www.pistar.uk/downloads/]] for instructions), the following configuration should be done. To configure the freshly installed Pi-Star, connect to the
11 -
12 -[[image:radiolog_cfg1.png]][[image:radiolog_cfg2.png]][[image:radiolog_cfg3.png]][[image:radiolog_cfg4.png]][[image:radiolog_cfg5.png]]
8 +Pi-Star has to be installed on a Raspberry Pi (Zero) with a MMDVM HAT. A
radiolog_cfg1.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.dingo
Size
... ... @@ -1,1 +1,0 @@
1 -76.9 KB
Content
radiolog_cfg2.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.dingo
Size
... ... @@ -1,1 +1,0 @@
1 -87.7 KB
Content
radiolog_cfg3.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.dingo
Size
... ... @@ -1,1 +1,0 @@
1 -82.8 KB
Content
radiolog_cfg4.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.dingo
Size
... ... @@ -1,1 +1,0 @@
1 -77.9 KB
Content
radiolog_cfg5.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.dingo
Size
... ... @@ -1,1 +1,0 @@
1 -19.2 KB
Content