Skip to Content

Changes for page Radio Log

Last modified by Treyfane Dingo on 2025/04/27 13:33
From version 10.12
edited by Treyfane Dingo
on 2025/04/07 20:52
Change comment: There is no comment for this version
To version 10.13
edited by Treyfane Dingo
on 2025/04/07 20:54
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -3,21 +3,8 @@
3 3  
4 4  The Radio Log is a module, which can be called by pressing F8 anywhere in L.A.S.S.I.E.. It will be available if L.A.S.S.I.E. is connected to a [[Pi-Star>>https://www.pistar.uk/]] with [[pistarlog2ws>>https://git.furcom.org/Dingo/pistarlog2ws]] installed (green antenna symbol) and subsequently show the DMR radio traffic.
5 5  
6 -= Pi-Star =
6 += Pi-Star Configuration =
7 7  
8 -== Installation ==
8 +Pi-Star has to be installed on a Raspberry Pi (Zero) with a MMDVM HAT. A non-duplex MMDVM HAT is fully sufficient since Pi-Star only can monitor one single frequency and sending is not something this setup is expected to do.
9 9  
10 -Pi-Star has to be installed on a Raspberry Pi (Zero) with a MMDVM HAT. A non-duplex MMDVM HAT is fully sufficient since Pi-Star only can monitor one single frequency and sending is not something this setup is expected to do. See [[https:~~/~~/www.pistar.uk/downloads/>>https://www.pistar.uk/downloads/]] for download and installation instructions.
11 -
12 -The image will be flashed to a SD card using the [[Raspberry Pi Imager>>https://www.raspberrypi.com/documentation/computers/getting-started.html#raspberry-pi-imager]]. During the installation, when prompted if you like to apply OS customization settings
13 -
14 -== Configuration ==
15 -
16 -After Pi-Star is installed , the following configuration should be done. To configure the freshly installed Pi-Star, connect to the web interface using your hostname, e.g. [[http:~~/~~/radiolog.local/admin/>>http://radiolog.local/admin/]].
17 -
18 -Default Username: pi-star
19 -Default Password: raspberry
20 -
21 -
22 -
23 -[[image:radiolog_cfg1.png]][[image:radiolog_cfg2.png]][[image:radiolog_cfg3.png]][[image:radiolog_cfg4.png]][[image:radiolog_cfg5.png]]
10 +After Pi-Star is installed (see [[https:~~/~~/www.pistar.uk/downloads/>>https://www.pistar.uk/downloads/]] for instructions), the following configuration should be done.